8/6/2023 0 Comments Freecad contour shuttle![]() One is to think about the limits of Path-WB from the ground up when developing my 3D model. At the moment, there is momentum towards releasing v17, and so there's a lot of tidying up and things do change in use as well at times, so the each time you upgrade, things may behave a bit differently.įor myself, I have had success in working around the few things that otherwise are difficult by adopting some strategies. One example of many is how Shai's Path-Simulation went from a discussion to an integrated reality in less than a month I think. That said, it sure is exciting to me seeing how quickly improvements roll out. * Do we need a horizontal clearance distance in addition to a vertical clearance distance?Īll of these questions are solvable, of course, but the overall solution is probably more complex than a simple contour around a solid object.Īt least for now, FreeCAD Path-WB has areas that are open to further development. * Does the model "box" indicate full clearance from all obstructions. * Do you want the tool to offset in the working plane and then return to the starting point for another pass? * Do you want the tool to lift to the clearance height and then start another active pass? * Do you want the return path to be a zig-zag down the vertical face that is being processed, actively working in both directions? Otherwise it eventually runs off the end of the earth. Sooner or later the tool needs to return to the starting area. This sort of path is often desirable however, the definition and implementation might not be an straightforward as seems at first. This operation is not implemented, so the error messages merely state that fact in complex language. 17PRe\FreeCAD_7_圆4_dev_win\FreeCAD_7_圆4_dev_win\Mod\Path\PathScripts\PathProfileEdges.py", line 92, in areaOpShapesį = Part.makeFace(wire, 'Part::FaceMakerSimple') 17PRe\FreeCAD_7_圆4_dev_win\FreeCAD_7_圆4_dev_win\Mod\Path\PathScripts\PathAreaOp.py", line 240, in opExecuteįile "E:\Downloads\FreeCad. 17PRe\FreeCAD_7_圆4_dev_win\FreeCAD_7_圆4_dev_win\Mod\Path\PathScripts\PathOp.py", line 417, in executeįile "E:\Downloads\FreeCad. ![]() 17PRe\FreeCAD_7_圆4_dev_win\FreeCAD_7_圆4_dev_win\Mod\Path\PathScripts\PathUtils.py", line 60, in new_functionįile "E:\Downloads\FreeCad. Here's what i'm getting from the Report Viewįile "E:\Downloads\FreeCad. The path profile for edge works fine if the edge is closed. I'm trying to do the same thing and I cannot get the profile on an open edge to work. Were you able to find a solution to this issue?
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |